10-watt PIR Sensor Bulb
Perfect for hallways, entrances, lobbies, rest homes and garages where security and safety is required or where inaccessible switches are present.
The enerx 10-watt LED PIR sensor bulb is a unique lamp with an inbuilt motion sensor. It uses PIR intelligent control to detect body movement up to five meters away. Automatic night time only operation is achieved by the built in photo switch.
It has good thermal management with energy saying of 80% over equivalent incandescent bulb.
It gives out a nice warm colour of 810 (75W) lumens and contain NO Mercury, Toxic or dangerous substances. They transmit NO infrared or UV radiation.
Each enerx 10-watt PIR sensor bulb is available with an Edison Screw and Bayonet Cap base.
enerx 10-watt LED Sensor Bulb
Please read this maual carefully before using this lamp in order to operate it correctly. This is a new energy saving lamp and is replacing a traditional incandedcent or CFL lamp.
Light automatically powers on lamp when motion is detected for an initial 45 seconds. After initial 45 seconds, if motion is still detected, on period extends by another 45 second intervals'. Motion detection range is 5 meters at 120° from centre of radar sensor. When detection ceases, time delay will continue for 45 seconds, then turn lamp off automatically. Built in day light sensor disables automatic operation when light level is above 5 Lux.
Be sure power is OFF to light circuit before replacing lamp. Do not install above 4.5 meters from floor. Allow old incandescent or CFL lamps to cool before removing. Do not install in areas with contact with rain.
Install new LED PIR sensor bulb into light socket. Do not over tighten when screwing lamp into edison screw socket.
Lamp will light for 30 seconds and then convert to standby mode if daylight is detected. if more then one bulb is on the switch circuit it is recommended replacing all bulbs with PIR sensor lamps.
10-watt Sensor Bulb
|Ac input Voltage||AC 100-265v 50Hz|
|Power dissipation||10.0 watts|
|Luminous flux||810 Lumens|
|Lighting Source||SMD 2835|
|Sensor Type||PIR + Light Sensor|
|Time Delay||30 seconds|
|Base||Edison Screw (E27) or Bayonet Cap (B22)|
|Dimensions||Ø60 x 110mm|
|Part No:||EX-BCSB10WW EX-ESSB10WW|
Conformite Europeene (French)
Tested to all the relevant standards that the EU demands.
Restriction of Hazardous Substances
Restriction of the use of certain Hazardous Substances in electrical and electronic equipment . Each individual piece of a finished product must meet all RoHS standards.
Frederal Communications Commission
Rating of electronic Equipment in either class A or class B. R. F. Emissions are so low that they do not interere with other devices such as radio's and TV's.
Complies to Relevant New Zealand Standards. Suppliers Declaration of Conformity form can be issued.